|
NewNet Direct Cisco 24
Meg Router Configuration
Windows
& Mac Installation
Please read the following
configuration instructions...
To begin configuring your Cisco Wireless Router please ensure your computer is turned on and the Cisco router is connected to your computer via the Ethernet cable provided and
turned on. See
Here
Step 1. Open an
Internet browser window (IE, Firefox etc.) and enter your Gateway IP in
the address bar of your browser window. e.g.
http://192.168.1.1 and click "go".
You will be prompted to enter a
Username and Password, please enter the following:
Username:
admin
Password: admin
and click 'OK'
Step2. This
will present you with the basic ADSL settings. Please Change
the
ADSL settings to match the screenshot below . The settings that require
changing have been highlighted in red.
N.B.
please ensure you enter your full adsl user name as provided on your
welcome e-mail, e.g.
your_username@adsl.newnet.co.uk
Step
3. Click 'Save
Settings' at the bottom of the ADSL Settings screen to
save
the changes. After clicking Save settings you will see the progress bar
in the bottom right hand corner move slowly as the router saves the
settings. This may take 20-30
seconds to update.
Step
4. Change the default password for the router login.
Newnet always recommends that users
change
the default password for their router. To do so please click on 'Administration' on
the menu at the top of the screen
Step
5.
Under Gateway password type the new password you wish to use
for
the router login and confirm below. Click 'Save Settings' This
password is only used to log
into the router status and settings page as described in step 1.
Make sure that the password is
something that you will remember - good passwords include a combination
of
numbers and letters.
Congratulations!
You are now connected to NewNet Direct
24meg broadband!
Support
Enquiries
Tel: 0845 684 0689
E-mail: support@newnet.co.uk
| 
